Test yourself with these sample questions

return to Table of Contents

more?

comments?

You should AVERAGE answering each question in less than 100 seconds for this exam

Note: All of the following questions contain only one best answer. Circle the letter that best corresponds with the question.

TEST

1.

Examples of Preliminary treatment in a wastewater treatment plant are:

 

 

 

 

a.

dissolved and colloidal organic matter.

b.

disinfection

c.

bar racks and screens

d.

WAS and RAS

2. 

EPA Form 3320 must be completed each month and submitted to the Georgia EPD by:

 

 

 

 

a.

the first of every month

b.

the 15th of the next month

c.

the end of every month

d.

the end of the year

3

A sample that is collected at a particular instant of time and reflects the source material conditions is a/an:

 

 

 

 

a.

Grab sample

b.

Automated sample

c.

Composite sample

d.

Flow proportional composite

4

The explosion in the growth rate of algae is called:

 

 

 

 

a.

air stripping

b.

decomposition

c.

photosynthesis

d.

a bloom

5

 A cubic foot of water contains 7.48 gallons of water. A gallon of water weighs 8.34 pounds. How many gallons of water are in a circular tank 37 feet high and 85 feet in diameter?

 

 

 

 

a.

 209,956

b.

1,570,475

c.

 1,751,037

d.

73509

6

 Retention (detention or residence) times in tanks are measured in terms of the volume divided by the flow rate. What is the retention time for a sedimentation basin 135 feet long by 45 feet wide and 11 feet deep when the flow is 2.75 MGD?

 

 

 

 

a.

 5 hours 26 minutes

b.

 4 hours 52 minutes

c.

 4 hours 36 minutes

d.

 3 hours 82 minutes

7

Determine the median value of the following data.

220,7200,230,300,240,270,240,250,240,260 

 

 

 

 

a.

945

b.

245 

c.

300 

d.

250 

8

The two controls of a Chemical feed pump are:

 

 

 

 

a.

concentration and on/off switch

b.

accelerator and gearshift

c.

rate and stroke

d.

influent control valve and ppm

9

A 100 HP motor should be

 

 

 

 

a.

greased daily

b.

pulsed on until up to speed

c.

turned on no sooner than once in twenty minutes

d.

always "soft started"

 10

MSDS is an acronym for

 

 

 

 

a.

Material Storage Data System

b.

Management Safety Data System

c.

Maintenance and Safety Data Storage

d.

Material Safety Data Sheet

11

The secondary effluent flow at a treatment plant is 4.8 MGD. After 30 minutes of contact time, the chlorine residual is measured at 0.5 mg/L. If the chlorinator is feeding chlorine at the rate of 300 lbs/day, what is the chlorine dosage?

 

 

 

 

a.

20.0 mg/L

b.

8.36 mg/L

c.

7.49 mg/L

d.

2009.6 mg/L

12

In the immediately previous question, what is the chlorine demand?

 

 

 

 

a.

19.5mg/L

b.

7.86 mg/L

c.

11959.6 mg/L

d.

7.0 mg/L

 13

 

 

 

 

 

a.

 

b.

 

c.

 

d.

 

 14

 

 

 

 

 

a.

 

b.

 

c.

 

d.

 

 15

 

 

 

 

 

a.

 

b.

 

c.

 

d.